A bit of errata on the micparts rk-47/990B kit microphone build report yesterday:
First, I didn’t mention that the board kit includes extra capacitors, to be used either for different capsules than I chose, or to tailor the response curve of the microphone. I went for flattest response, but I could’ve had more or less high-end responsiveness by choosing which included tone capacitors to use.
Second, I said that the “omni” switch setting probably wasn’t really going to be actually “omni,” but was more likely to be figure-eight or the like. This was in response to both the capsule design, grille design, and older pictures of the circuit board which appeared to indicate that. In testing, I discovered that I was mistaken – as you can see here, levels as seen in waveforms made by holding a tone generator at the four cardinal directions remain constant. But read on, after the graphs, because there’s a catch:
rk-47 set to omni, against tone generator at 30cm, front, right, rear, left positions
And here’s the same test, with the mic set to cardioid:
rk-47 set to cardioid, against tone generator at 30cm, front, right, rear, left positions
And here’s an M-Audio Nova, same conditions, for comparison:
nova, cardioid, against tone generator at 30cm, front, right, rear, left positions
The total pickup is certainly omnidirectional. But this is not a true basket head on this thing, there are support brackets on the left and right sides, and that does affect tone! High-end harmonics definitely fall off on the left and right sides.
So while it does qualify as an omnidirectional microphone in “omni” mode, I’d have to call it flawed in that mode, and use something else – like an Oktava 012 with the omnidirectional head, which is built for true omnidirectional pickup and does not exhibit this behaviour.
Alternately, I suppose it might be usable in that mode if you’re recording someone who is a tad screechy – aim the wrong side at the performer and presto, fewer high harmonics. EVERYBODY WINS XD